This summary gives a short overview of AFB staining and Albert’s staining which are routinely used staining methods in the microbiology laboratory. In key points it is explained how the AFB staining is a differential staining used for demonstration of Mycobacterium tuberculosis, Mycobacterium leprae and other acid fast bacilli. Albert’s staining is a special stain for demonstrating metachromatic granules of Corynebacterium Diphtheriae.
Table of Contents
CHAPTER I
AFB STAINING
CHAPTER II
Albert’s staining method
Objectives and Topics
This document serves as a technical guide to fundamental microbial staining techniques, specifically detailing the protocols for Acid-Fast Bacilli (AFB) staining and Albert’s staining. The primary objective is to provide a standardized, step-by-step methodology for laboratory professionals to accurately identify specific pathogens, such as Mycobacterium species and Corynebacterium diphtheriae, through precise reagent preparation and microscopic observation.
- Detailed methodology for Ziehl-Neelsen and Kinyoun Acid-Fast staining
- Clinical procedures for sputum sample preparation and grading
- Fluorochrome staining principles for rapid diagnostic screening
- Albert’s staining protocol for the demonstration of metachromatic granules
- Comparative analysis of diagnostic reagents and reporting standards
Excerpt from the Book
Staining:
Place the slides in serial order on the leveled staining rack. Leave enough space between slides to prevent the transfer of material or staining solution from one smear to another.
Cover the entire surface of the slide with 1 % filtered carbol fuchsin solution.
Heat the slide with Bunsen burner or alcohol soaked cotton swab till steam arises. Let the slide stand for 5 min. Do not allow the stain to dry on the slide. If necessary put more carbol fuchsin.
Rinse the slide with tap water. Drain off excess water.
Decolorize with 20% H2SO4 for 2-4 min. wash the slide with water. again pour fresh acid. Repeat several times till the stain is faint pink. This requires a total time of at least 10 min.
Counter stain with 1% methylene blue & let stand for 30 sec to 1 min.
Gently rinse with tap water. Allow the slide to dry or blot with filter paper.
Examine the slides under the microscope oil immersion lens.
Mycobacteria appear Acid fast (red), long, slender, slightly curved with barred or beaded appearance.
Summary of Chapters
CHAPTER I: This chapter covers the principles, reagents, and procedural steps for various Acid-Fast staining methods, including Ziehl-Neelsen and Fluorochrome techniques, along with grading systems for sputum samples.
Albert’s staining method: This chapter describes the specific protocol for identifying metachromatic granules in Corynebacterium diphtheriae using Albert’s staining and provides a comparison with other alternative staining methods.
Keywords
AFB Staining, Ziehl-Neelsen, Mycobacterium, Acid-Fast, Sputum, Fluorochrome, Auramine-O, Albert’s Staining, Corynebacterium diphtheriae, Metachromatic granules, Microbiology, Lab diagnostic, Bacteriology, Decolouriser, Counterstain
Frequently Asked Questions
What is the primary focus of this laboratory manual?
The manual focuses on providing standardized protocols for microbiological staining techniques used in the identification of specific bacteria, particularly those requiring acid-fast and metachromatic granule staining.
Which organisms are typically identified using Acid-Fast staining?
Acid-Fast staining is primarily used to identify Mycobacterium species, Nocardia, Rhodococcus, and certain parasites like Cryptosporidium and Isospora.
What is the core difference between the Ziehl-Neelsen and Kinyoun methods?
The Ziehl-Neelsen method is a "hot stain" requiring heat to facilitate dye penetration, whereas the Kinyoun method is a "cold stain" that achieves similar results by increasing the concentration of carbol fuchsin and phenol.
Which diagnostic method is recommended for high-volume rapid screening of AFB?
Fluorochrome staining, using dyes like Auramine-O, is recommended as it allows for the scanning of larger areas of the smear in less time, offering higher sensitivity.
What is the clinical significance of Albert’s staining?
Albert’s staining is specifically used to demonstrate metachromatic granules in Corynebacterium diphtheriae, which is essential for the laboratory diagnosis of diphtheria.
How is the diagnostic effectiveness of AFB staining monitored during treatment?
The effectiveness is monitored by assessing the number of acid-fast organisms in serial sputum smears; a failure to decrease the organism count may indicate the development of drug resistance.
What role does the "Bacteriological Index" play in leprosy diagnosis?
The Bacteriological Index provides a semi-quantitative measure of the mycobacterial load found across multiple skin lesions and smears, helping clinicians evaluate the extent of infection.
Why is 20% H2SO4 used in the Ziehl-Neelsen staining procedure?
It acts as a critical decolouriser that removes the primary stain from non-acid-fast organisms while leaving the waxy-walled acid-fast bacilli stained red.
- Citar trabajo
- Dr. Gargi Dangre-Mudey (Autor), 2015, Summary of Staining Methods. AFB Staining and Albert's Staining, Múnich, GRIN Verlag, https://www.grin.com/document/303648
